Removing and installing front toothed belt guard (fully enclosing) — AUDI

🧭 Before you start

Fits: platform codes S1, 2H

🔧 Engine codes this applies to

📐 25 workshop diagrams for CDBA

Real factory drawings for this job — timing marks, bolt locations and routing. Locked in the free view.

📋 Procedure

1. If fitted, remove air supply hose .
2. Remove bolt (2).
3. Move bracket with coolant pipe (1) slightly to one side.
4. Release clips (3).
5. Unscrew bolts (2).

6. Carefully pull toothed belt guard (1) in direction of (arrow) out of locking lugs (arrows).
7. To ease installation, spray front toothed belt guard (1) with silicone lubricantElectronic Parts Catalogue.
8. First, insert toothed belt guard (1) with locking lugs (arrows) in lower toothed belt guard.
9. Then, engage clips and tighten bolts (if necessary, push slightly against toothed belt guard to engage clips).
10. If removed beforehand, reinstall underbody guard General body repairs, exterior66Underbody guard; Removing and installing underbody guard.

Other AUDI procedures

• Checking fuel low-pressure ahead of fuel filter
• Checking fuel filter
• Assembly overview - turbocharger, single turbo
• Removing and installing turbocharger, single turbo
• Checking fuel low-pressure at high-pressure pump
• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures