Removing and installing front three-point seat belt, Transporter — AUDI
Removing and installing front three-point seat belt, Transporter on Audi: 15 steps. What to remove, in what order, and what to check after.
Workshop procedure for AUDI — the exact step sequence and torque figures, straight from real workshop data.
🧭 Before you start
Fits: platform codes SF, SG
📋 Procedure
- Switch on ignition.
- Disconnect battery Electrical system27Battery; Disconnecting and connecting battery.
- Remove upper B-pillar trim .
- Remove lower B-pillar trim .
- Remove bolt (1).
- Detach end belt end fitting (2) from body.
- Remove bolt (3).
- Remove belt inertia reel (4) from B-pillar.
- ⚠ Electrostatic discharges may result in unintentional triggering of belt tensioner. Therefore, the mechanic must electrostatically discharge him/herself before disconnecting the igniter and earth wires. This can be done by briefly touching the body or striker plate of the door. — Disconnect connector (5).
- Remove bolts (6).
- Remove belt guide (7).
- Unclip cover (9).
- Remove bolt (8).
- Detach belt guide fitting (10) from belt height adjuster.
- Connect battery Electrical system27Battery; Disconnecting and connecting battery.
Other AUDI procedures
- Removing and installing toothed belt – Audi · 56 torque figures
- Removing engine – Audi A8 D3 · 41 torque figures
- Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
- Installing engine – Audi A8 D4 · 36 torque figures
- Removing and installing camshaft timing chain · 29 torque figures
- Removing and installing valve body · 5 torque figures
- Removing and installing front axle suspension strut (allroad) · 7 torque figures
- Adjusting input shaft – Audi TT Mk1 · 9 torque figures
- Removing and installing bumper (front) – Audi Q7 · 7 torque figures
- Removing and installing drive chain for auxiliary drives · 7 torque figures
Who makes these pages, and how
TorqFix was built by a mechanic — after a 2,700 km drive with five roadside repairs that no diagnostic tool could explain.
The figures on this page come from manufacturer workshop documentation and are shown as they are. The page is assembled automatically from that data — it is not written by an AI. The AI works in the chat, where it answers for your specific car. It writes nothing here.
Variants of the same model differ. Cross-check torque against the factory manual for your engine before final tightening.
Seen a figure that does not match your manual? Write to us — we correct it and note when. support@torqfix.com
The story behind TorqFix →Workshop data on this page last updated 20 Sep 2026.