Removing and installing front spoiler — AUDI
Removing and installing front spoiler on Audi: 12 steps. What to remove, in what order, and what to check after.
Workshop procedure for AUDI — the exact step sequence and torque figures, straight from real workshop data.
🧭 Before you start
Fits: VW Caddy III (2K, 2004–2015); platform code 2C0
Don't miss
- Before removing front spoiler (3), gently heat it with hot air blowerV.A.G 1416.
- Fit front spoiler (3) to front bumper cover (1), and ensure that ends of protective film of double-sided adhesive tape are accessible.
- Firmly press front spoiler (3) on front bumper cover (1) along area to be bonded. Counterhold on inside while doing so.
📋 Procedure
- Remove front bumper cover .
- Remove bolts (6).
- Release skid plate from fasteners on front spoiler to remove.
- Unclip spreader clips (4) (qty. 14) from front spoiler (3).
- Before removing front spoiler (3), gently heat it with hot air blowerV.A.G 1416.
- Carefully fit removal wedge3409 between front spoiler (3) and front bumper cover (1).
- Pull front spoiler (3) off front bumper cover (1) making sure not to use excessive force. [Note: When installing the front spoiler, ensure that the paintwork of the front bumper cover is not damaged.The front bumper cover must not be twisted or bent when affixing the front spoiler.When the front spoiler is pressed on during bonding, a strong force must be applied evenly from the outside.]
- Drill holes (qty. 14) at marked points on front bumper cover (1), and remove burrs.
- Fit front spoiler (3) to front bumper cover (1), and ensure that ends of protective film of double-sided adhesive tape are accessible.
- Align front spoiler (3), and pull off protective film.
- Firmly press front spoiler (3) on front bumper cover (1) along area to be bonded. Counterhold on inside while doing so.
- Insert spreader clips (4).
Other AUDI procedures
- Removing and installing toothed belt – Audi · 56 torque figures
- Removing engine – Audi A8 D3 · 41 torque figures
- Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
- Installing engine – Audi A8 D4 · 36 torque figures
- Removing and installing camshaft timing chain · 29 torque figures
- 6-cylinder direct petrol injection engine (3.2 ltr. 4-valve), mechanics — Securing engine to engine and gearbox support · 1 torque figures
- Removing and installing backrest cover and padding - fixed rear seat backrest
- Removing and installing bonnet lock
- Adjusting striker – Audi A5 Cabriolet · 1 torque figures
- Removing and installing exterior mirror turn signal bulb L131/L132
Who makes these pages, and how
TorqFix was built by a mechanic — after a 2,700 km drive with five roadside repairs that no diagnostic tool could explain.
The figures on this page come from manufacturer workshop documentation and are shown as they are. The page is assembled automatically from that data — it is not written by an AI. The AI works in the chat, where it answers for your specific car. It writes nothing here.
Variants of the same model differ. Cross-check torque against the factory manual for your engine before final tightening.
Seen a figure that does not match your manual? Write to us — we correct it and note when. support@torqfix.com
The story behind TorqFix →Workshop data on this page last updated 20 Sep 2026.