Removing and installing front reception aerials: Audi A8 D3

🧭 Before you start

Fits: Audi A8 D3 (4E, 2002–2010)

🔩 Torque settings

Values can differ between engine variants — check the code stamped on your block.

ℹ️ Always cross-check the exact figure against your vehicle's factory manual before final tightening — a wrong torque can damage the engine. These values are extracted from workshop data and may not cover every variant or revision.

📋 Procedure

1. Position vehicle on lifting platform .
2. Switch off ignition.
3. Remove wheel housing liner 66.
4. Unplug connector (1).
5. Release clip (2).

6. Take out aerial (3).
7. Unscrew hexagon nut (1).
8. Take out aerial bracket (2).
9. Tighten hexagon nut (1) to 2 Nm. — 2 Nm (1.5 lb-ft)
10. Fit wheel housing liner 66.
11. Set down vehicle on its wheels .

Other AUDI procedures

• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures
• Removing and installing third rear three-point seat belt (folding backrest, rear)
• Removing and installing ISOFIX retainer (front) – Audi · 1 torque figures
• Removing front seat in event of defective seat longitudinal adjustment motor or control unit
• Removing seat in event of defective control unit or defective longitudinal adjustment motor
• Checking fuel temperature sender G81