Removing and installing fixed lightweight rear seat backrest — AUDI

🧭 Before you start

Fits: Audi A2 (8Z)

• Timing position: the crankshaft or camshaft is set and locked during this job
• Special tools named: locking pin

📋 Procedure

1. Remove rear seat bench .
2. Remove buckle plate (2).
3. Unclip upper attachment trim (3).
4. Unscrew bolt (4) and detach holder (6).
5. Press locking pin (7) to rear in direction of arrow until it engages. In this process, hook (8) opens rear fastener (9).

6. Swivel rear seat backrest forwards into vertical position (approx. 20°).
7. Detach rear seat backrest vertically upwards from rear fasteners (9).
8. Take rear seat backrest out of vehicle.
9. Position rear seat backrest in vehicle.
10. Align hook (8) with rear fastener (9).
11. Swivel rear seat backrest to rear until it makes contact with upper attachment (5).
12. Press locking pin (7) forwards until it engages. In this process, hook (8) locks rear fastener (9).
13. Fit holder (6) with bolt (4).
14. Clip in upper attachment trim (3).
15. Fit buckle plate (2).
16. Fit rear seat bench .

Other AUDI procedures

• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures
• Removing and installing high-pressure pump - engine codes CAMA, CAMB, CCWA, CCWB, CGKA, CGKB, CCLA
• Draining active tank for reducing agent
• Removing and installing glow plugs - engine code CCLA
• Removing and installing fuel gauge senderG - A5 models from model year 2012 onwards, A4 models from model year 2013 onwards (vehicles with front-wheel drive)
• Draining fuel tank - rest-of-world vehicles with four-wheel drive