Removing and installing exterior mirror (electrically adjustable) — AUDI

🧭 Before you start

Fits: platform codes 2EA, 2ED, 2EH, 2EX, 2EB, 2EE, 2EK, 2FC, 2FF, 2FL, 2FZ, 2FG, 2FM

📋 Procedure

1. Lever cap (4) out of opening on inside of front door.
2. Unscrew bolts (3) from inside of front door and remove exterior mirror (1) from front door.
3. Separate electrical connector (2).
4. Remove front door trim General body repairs, interior70Trims/insulation; Door trims.
5. Disconnect connector for exterior mirror on door shell.

6. Lever cap (4) out of opening on inside of front door.
7. Unscrew bolts (3) from inside of front door and remove exterior mirror from front door.
8. Pull out cable through hole in door.
9. Remove front door trim General body repairs, interior70Trims/insulation; Door trims.
10. Pull bellows off retaining ring on A-pillar, and disconnect connector.
11. Lever cap (4) out of opening on inside of front door.
12. Unscrew bolts (3) from inside of front door and remove exterior mirror from front door.
13. Pull out cable through hole in door.

Other AUDI procedures

• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures
• Testing operation of the Lambda control – Audi 4.2 AHK
• Testing idling stabilisation valve – Audi 4.2 AHK
• Testing and adjusting idling switch – Audi 4.2 AHK
• Testing intake manifold changeover valve
• Testing power supply relay for Motronic system – Audi 4.2 AHK