Removing and installing engine mounting without cover for engine mounting — AUDI

🧭 Before you start

Fits: Audi A2 (8Z)

• Special tools named: T40093/6

Don't miss

• Disregard (item 3).
• Do not loosen nut (3) unless renewing engine mounting.

🔧 Engine codes this applies to

📋 Procedure

1. Remove bonnet .
2. Disconnect resonator, if fitted.
3. Unplug electrical connector (2) at air mass meter G70.
4. Detach vacuum hose (1).
5. Release hose clip (4) and move air pipe with air mass meter G70 to front. [Note: Disregard (item 3).]

6. Set up support bracket10 - 222 A with adapters 10 - 222 A /13 and adapter T40093/6 on wing panel flanges.
7. ⚠ At the same time, engage adapter10 - 222 A /13 in mountings for bonnet (arrow). — Attach hook on spindle10 - 222 A /11 to engine lifting eye.
8. Take up weight of engine using spindle (but do not raise engine). [Note: Do not loosen nut (3) unless renewing engine mounting.]
9. Remove bolts (1 and 2) and detach support arm with engine mounting. [Note: Renew the bolts tightened with specified tightening angle.Hose connections and hoses for charge air system must be free of oil and grease before assembly. Do NOT use lubricant.Secure all hose connections with the correct type of hose clips (same as original equipment) Parts catalogue.Fit all cable ties in the original positions when installing.]
10. Install air pipes/hoses with plug-in connectors .

Other AUDI procedures

• Seat Arosa 1.4 TDi mech AMF timing belt replacement
• Arosa 1.4 TDi (AMF) hydr
• Adapting functions and components
• Removing and installing engine mounting with cover for engine mounting
• Removing and installing accelerator pedal module with accelerator position sender
• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures