Removing and installing electrical rear roller blind (sun blind) — AUDI
Removing and installing electrical rear roller blind (sun blind) on Audi: 11 steps. What to remove, in what order, and what to check after.
Workshop procedure for AUDI — the exact step sequence and torque figures, straight from real workshop data.
🧭 Before you start
Fits: Audi A6 C6 (4F, 2004–2011)
📋 Procedure
- Retract sun blind (rear) (3).
- Remove rear shelf with sun blind (rear) .
- Pull out sun blind (rear) (3) approx. 50 mm at covers with wheel (6).
- Wedge a suitable object in between sun blind (rear) (3) and rear shelf (1).
- Unscrew bolts (5) (2x).
- Pull out covers with wheel (6) (left and right) in direction of (arrow).
- Detach wiring harness from rear shelf (1).
- Unscrew nuts (4) (8x).
- Detach sun blind (rear) (3) from rear shelf (1).
- Install in reverse order of removal.
- Check operation of electrical rear roller blind (3) (sun blind).
Other AUDI procedures
- Removing and installing toothed belt – Audi · 56 torque figures
- Removing engine – Audi A8 D3 · 41 torque figures
- Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
- Installing engine – Audi A8 D4 · 36 torque figures
- Removing and installing camshaft timing chain · 29 torque figures
- Checking delivery pressure of power steering pump (vehicles with 10-cylinder petrol engine)
- Removing and installing engine compartment cross member - R8 Spyder with manual gearbox/R tronic gearbox 086
- Removing and installing coolant pipes located at centre of vehicle
- Removing and installing mounting bracket for clutch pedal and clutch master cylinder
- Removing and installing convertible roof with convertible roof frame
Who makes these pages, and how
TorqFix was built by a mechanic — after a 2,700 km drive with five roadside repairs that no diagnostic tool could explain.
The figures on this page come from manufacturer workshop documentation and are shown as they are. The page is assembled automatically from that data — it is not written by an AI. The AI works in the chat, where it answers for your specific car. It writes nothing here.
Variants of the same model differ. Cross-check torque against the factory manual for your engine before final tightening.
Seen a figure that does not match your manual? Write to us — we correct it and note when. support@torqfix.com
The story behind TorqFix →Workshop data on this page last updated 20 Sep 2026.