Removing and installing electric sliding door control unit, left sliding door — AUDI

🧭 Before you start

Fits: VW Transporter T5 (7H), VW Transporter T5 (7J), VW Transporter T6 (7E), VW Transporter T6 (7F)

Don't miss

• On new vehicles, this supporting unit is not available any more.

📋 Procedure

1. Switch off ignition and all electrical loads, and pull out ignition key.
2. Remove storage compartment cover (arrow) from side panel trim.
3. Detach carrier unit (arrow) of loudspeaker connectors.
4. Detach carrier unit of electrical connectors. [Note: On new vehicles, this supporting unit is not available any more.]
5. Push coupling station towards left as far as possible.

6. Unscrew the two securing bolts arrows from bracket for electric sliding door control unit.
7. Remove control unit together with bracket from D-pillar.
8. Release and disconnect connectors on control unit.
9. Unbolt control unit from bracket and remove it.

Other AUDI procedures

• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures
• Testing solenoid valves for camshaft timing control – Audi 2.7
• Removing and installing auxiliary water pump – Audi 2.7 AGB
• Testing charge pressure control function via load signal
• Testing function of exhaust gas temperature senders (display groups 200/201 and 202) - vehicles with engine code AGB only
• Removing and installing convertible top frame with cover and headliner