Removing and installing driver seat/front passenger seat memory operating unit E97/E277 — AUDI

🧭 Before you start

Fits: Audi A8 D3 (4E, 2002–2010)

📋 Procedure

1. Switch off ignition and take out ignition key.
2. Remove door trim (front) 70.
3. Detach insulating mat from door trim.
4. Unscrew bolts (arrows) and detach loudspeaker trim.
5. Unplug electrical connector (1).

6. Unscrew bolts (arrows) and detach storage compartment from door trim.
7. Use Allen key to remove pin (1) for actuation of storage compartment lock and pin (2) for stop.
8. Repeat procedure on other side of storage compartment.
9. Open storage compartment.
10. Remove switch trim (1)(arrows).
11. Lift switch at rear (arrow 1) and detach towards inside of storage compartment (arrow 2).
12. Unplug electrical connector (1).
13. Use small screwdriver to carefully release retaining hooks (arrows).
14. Pull driver seat/front passenger seat memory operating unit (2) downwards out of switch mounting.
15. Press driver seat/passenger seat memory operating unit into switch mounting until retaining hooks engage.
16. Install door trim (front) 70.

Other AUDI procedures

• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures
• Differential - exploded view of components · 1 torque figures
• Removing and installing pinion shaft; dismantling and assembling pinion shaft
• Checking gear oil level in front final drive – Audi · 1 torque figures
• Renewing twin-lip oil seal in input pinion – Audi
• Removing and installing connector point in electronics box (plenum chamber)