Removing and installing dipped beam bulb M29/M31, headlights with H7 bulb, vehicles up to model year 2010 — AUDI

🧭 Before you start

Fits: VW Caddy III (2K, 2004–2015); platform code 2C0

📋 Procedure

1. Switch off ignition and all electrical loads, and pull out ignition key.
2. Push wire shackle to one side (1) in (direction of arrow).
3. Take cover cap (2) out through recesses in side of headlight.
4. Turn bulb holder by grip element (1) in (direction of arrow) and remove from headlight.
5. Pull dipped beam bulb(2) in (direction of arrow) straight out of bulb holder (1).

6. ⚠ When installing, make sure cover is correctly seated. The ingress of water will lead to permanent damage to the headlight.Do not touch bulb glass when installing a bulb. Fingers leave traces of grease on the glass, which evaporate when the bulb is switched on and cause the glass to cloud over. — Place bulb holder with dipped beam bulb in headlight and turn bulb holder by grip element (1) in (direction of arrow).
7. Put cap (2) into recess (1) of headlight and push fully into position.
8. Lock cap (2) in place by closed the wire shackle (1) in (direction of arrow).
9. Check function of headlight.
10. Checking and, if necessary, adjusting headlight setting .

Other AUDI procedures

• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures
• Removing and installing camshafts and hydraulic chain tensioner/camshaft adjuster
• Checking lambda probe and lambda control upstream of catalytic converter
• Removing and installing spoiler for rear lid - Saloon, equipment versions: S4 and S line up to VIN 400 000 · 2 torque figures
• Removing and installing front wheel bearing with wheel bearing housing installed
• Removing and installing power steering pump – Audi A6 C5