Removing and installing covers and padding of seats in 1st row — AUDI

🧭 Before you start

Fits: VW Caddy IV (SA, 2015–2020)

Don't miss

• The part numbers of the padding clips can be found in the Electronic Parts Catalogue (ETKA).

📋 Procedure

1. Remove individual seat or double bench seat .
2. Remove head restraint guides .
3. Remove trims of backrest fittings .
4. Remove padding and cover from seat cushion .
5. Remove front seat belt end anchor .

6. Lever out cap (1) and seat belt guide (2) from mountings.
7. Thread seat belt (4) and belt end fitting (3) through seat belt guide.
8. Fold backrest forwards.
9. Using a screwdriver, lever clamp profiles (1) and (2) on rear of backrest out of mountings.
10. Fold backrest backwards.
11. Detach padding with cover (3) from backrest frame (4).
12. Fold up cover (1).
13. Press apart sides of mountings (2) and pull out fastening strip (3).
14. Detach remaining connections.
15. Detach cover (1) from padding (4).
16. Attach cover (1) to padding (4) with new padding clips - at the positions indicated - using padding clip pliersV.A.G 1634. [Note: The part numbers of the padding clips can be found in the Electronic Parts Catalogue.]

Other AUDI procedures

• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures
• Removing and installing alternator - vehicles with 1.4 ltr. TFSI engine
• Removing and installing starter - vehicles with 1.2 ltr./1.4 ltr. TFSI engine and manual gearbox
• Checking fuel pump delivery rate – Audi A8 D3
• Renewing crankshaft oil seal (gearbox end) – Audi A6 C6
• Removing and installing valve for oil pressure control N428