Removing and installing cooler for engine oil and ATF — AUDI

🧭 Before you start

Fits: Audi Q7 (4L, 2005–2015)

• Renewed: o-rings

🔧 Engine codes this applies to

📋 Procedure

1. Remove bumper cover (front) 63.
2. Remove nuts (arrows) and lower radiator slightly.
3. Unclip air duct (1) and detach.
4. Remove bolt (arrow) (left and right) and tie up auxiliary radiator (centre) to bumper (coolant hose (2) remains connected).
5. Position used oil collection and extraction unitV.A.G 1782 below connection point.

6. Remove bolts (3) and (4) on both sides and detach engine oil pipes and ATF pipes.
7. Remove cooler for engine oil and ATF. [Note: Fit new O-rings.]
8. Install ATF pipes 37.
9. Install bumper cover (front) 63.
10. Check oil level 406.

Other AUDI procedures

• Installing high-pressure pipes – Audi A6 C6 · 2 torque figures
• Removing and installing fuel system pressurisation pump G6, vehicles with 3.0 ltr. (V6) or 4.2 ltr. (V8) engine from 06.2010 onwards
• Checking fuel system pressurisation pump G6, vehicles with 3.0 ltr. (V6) or 4.2 ltr. (V8) engine from 06.2010 onwards
• Removing and installing fuel system pressurisation pump G6, vehicles with 6.0 ltr. (V12) engine
• Removing and installing suction-jet pump (left-side), vehicles with 3.0 ltr. (V6) or 4.2 ltr. (V8) engine up to 05.2010
• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures