Removing and installing coolant pipe on gearbox (right-side) - vehicles with dual clutch gearbox 0B5/automatic gearbox 0BK — AUDI

🧭 Before you start

Fits: Audi A6/A7 C7 (4G, 2011–2018); platform code 4X

• Opens: coolant
• Special tools named: 3094

Don't miss

• The illustration shows dual clutch gearbox 0B5.

🔧 Engine codes this applies to

📋 Procedure

1. Remove engine cover panel .
2. ⚠ Hot steam/hot coolant can escape - risk of scalding.The cooling system is under pressure when the engine is hot.To allow pressure to dissipate, cover filler cap on coolant expansion tank with cloth and open carefully. — Open filler cap (arrow) on coolant expansion tank.
3. Remove noise insulation (rear) General body repairs, exterior66Noise insulation; Removing and installing noise insulation.
4. Remove bolts (arrows) and detach heat shield (right-side) (1) on subframe.
5. Place drip tray for workshop hoistVAS 6208 under connection.

6. Clamp off coolant hose (1) with hose clamp 3094.
7. Remove bolts (arrows).
8. Clamp off coolant hose (3) using hose clamp 3094, release hose clip and disconnect coolant hose from coolant pipe on right side of gearbox.
9. Release hose clip (2) and detach coolant pipe going to wheel housing (right-side). [Note: The illustration shows dual clutch gearbox 0B5.] [Note: Secure all hose connections with the correct type of hose clips (same as original equipment) Electronic parts catalogue.Do not reuse coolant.]
10. Fill up with coolant .

Other AUDI procedures

• Removing and installing injectors, MPI engines
• Removing and installing coolant circulation pump V50
• Removing and installing honeycomb filter – Audi A6/A7 C7 2.0
• Removing and installing stage 3 oil pressure switch F447
• Removing and installing Hall sender 3G300 – Audi A6/A7 C7
• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures