Removing and installing cable for bonnet lock: Audi A3

🧭 Before you start

Fits: Audi A3 (8P, 2003–2012)

Don't miss

• When installing, make sure you press grommet for cable (1) into bulkhead correctly.

🔩 Torque settings

Values can differ between engine variants — check the code stamped on your block.

ℹ️ Always cross-check the exact figure against your vehicle's factory manual before final tightening — a wrong torque can damage the engine. These values are extracted from workshop data and may not cover every variant or revision.

📋 Procedure

1. Separate cable at coupling unit (4).
2. Unfasten grommet (arrow) from bulkhead, pull cable (2) out from under the seal (3) and into the passenger compartment.
3. To remove release lever (3) unscrew bolts (2).
4. When installing, make sure you press grommet for cable (1) into bulkhead correctly.
5. When installing, tighten bolts to 2 Nm. — 2 Nm (1.5 lb-ft)
6. Clip (4) fitted in A-pillar (bottom).

Other AUDI procedures

• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures
• Removing and installing front seat – Audi Q7
• Removing and installing rain sensor – Audi A3
• Removing and installing alternator - vehicles with 1.9 ltr. TDI engine
• Removing and installing coolant pipe (front) - vehicles with 4/2-way valve
• Removing and installing high-pressure pump - vehicles up to 08.2005