Removing and installing burner head — AUDI
Removing and installing burner head on Audi: 11 steps. What to remove, in what order, and what to check after.
Workshop procedure for AUDI — the exact step sequence and torque figures, straight from real workshop data.
🧭 Before you start
Fits: platform code SG
📋 Procedure
- ⚠ Observe safety precautions: Liquid gas units . — Pull both rotary knobs (1) and (2) upwards off gas cooker.
- Unscrew nuts (1) from gas cooker (2).
- Pull both cooker grilles (1) out of gas cooker mounting brackets.
- Remove bolts (2).
- Remove cover (3).
- Remove both distributor heads (4).
- Remove sink with gas cooker .
- Unscrew nuts (1) from both burner heads on gas cooker (2).
- Remove connectors (1) on regulator (2).
- Screw on nuts (1) by hand.
- Screw on nuts (1) by hand.
Other AUDI procedures
- Removing and installing toothed belt – Audi · 56 torque figures
- Removing engine – Audi A8 D3 · 41 torque figures
- Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
- Installing engine – Audi A8 D4 · 36 torque figures
- Removing and installing camshaft timing chain · 29 torque figures
- Checking fuel temperature sender G81
- Removing and installing starter unit for gas discharge bulb - vehicles up to 08.2007
- Removing and installing front passenger seat adjustment switch E157
- Removing and installing glove box - vehicles with knee bolster / knee airbag (country-specific version)
- Removing warning lamp for airbag deactivated on front passenger side · 1 torque figures
Who makes these pages, and how
TorqFix was built by a mechanic — after a 2,700 km drive with five roadside repairs that no diagnostic tool could explain.
The figures on this page come from manufacturer workshop documentation and are shown as they are. The page is assembled automatically from that data — it is not written by an AI. The AI works in the chat, where it answers for your specific car. It writes nothing here.
Variants of the same model differ. Cross-check torque against the factory manual for your engine before final tightening.
Seen a figure that does not match your manual? Write to us — we correct it and note when. support@torqfix.com
The story behind TorqFix →Workshop data on this page last updated 20 Sep 2026.