Removing and installing brake light switchF, right-hand drive — AUDI

🧭 Before you start

Fits: VW Caddy III (2K, 2004–2015); platform code 2C0

Don't miss

• The brake light switchF must then be removed from below.

📋 Procedure

1. If fitted, remove heat shield (1) from diesel particulate filter by unscrewing nuts (arrows).
2. Remove upper timing belt guard by detaching clips (arrows).
3. Release electrical connector (2) from exhaust gas pressure sensor 1G450 and pull off.
4. Remove bolt (4).
5. Remove bolt (3).

6. Remove exhaust gas pressure sensor 1G450 and place aside.
7. Remove securing bolts (1) and take out bracket.
8. Unclip heat shield and place to one side.
9. Remove heat shield (3) (if fitted) by unscrewing nuts (4).
10. Separate connector (A) from brake light switchF and pull off. [Note: The brake light switchF must then be removed from below.]
11. Remove bolt (1) from brake master cylinder.
12. Pull brake light switchF(2) off the brake master cylinder underneath and out of the clip at the top (arrow).
13. Insert brake light switchF properly in guide.

Other AUDI procedures

• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures