Removing and installing bracket for shut-off valves: Audi A8 D4
Step-by-step removing and installing bracket for shut-off valves for the Audi A8 D4: 3 steps, 1 torque figure.
Workshop procedure for AUDI — the exact step sequence and torque figures, straight from real workshop data.
🧭 Before you start
Fits: Audi A8 D4 (4H, 2010–2017)
Don't miss
- This illustration shows the arrangement of the V50 and N82 on a vehicle with an 8-cyl. FSI engine without the auxiliary heater as an optional extra. The layout of V50 and N82 (or N279) may differ depending on vehicle equipment.
- This illustration shows the layout of N279 on a vehicle with auxiliary heater as optional extra. The layout of V50 and N82 (or N279) may differ depending on vehicle equipment.
🔩 Torque settings
Values can differ between engine variants — check the code stamped on your block.
| Torque | Fastener / step |
|---|---|
| 8 Nm (5.9 lb-ft) | Remove bolts (B) and nut with washer (C |
ℹ️ Always cross-check the exact figure against your vehicle's factory manual before final tightening — a wrong torque can damage the engine. These values are extracted from workshop data and may not cover every variant or revision.
📋 Procedure
- Unfasten V50 from bracket (A)Removing and installing coolant circulation pump V50. [Note: This illustration shows the arrangement of the V50 and N82 on a vehicle with an 8-cyl. FSI engine without the auxiliary heater as an optional extra. The layout of V50 and N82 (or N279) may differ depending on vehicle equipment.]
- Remove bolts (B) and nut with washer (C) (tightening torque: 8 Nm). — 8 Nm (5.9 lb-ft)
- Remove bracket (A). [Note: This illustration shows the layout of N279 on a vehicle with auxiliary heater as optional extra. The layout of V50 and N82 (or N279) may differ depending on vehicle equipment.]
Other AUDI procedures
- Removing and installing toothed belt – Audi · 56 torque figures
- Removing engine – Audi A8 D3 · 41 torque figures
- Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
- Installing engine – Audi A8 D4 · 36 torque figures
- Removing and installing camshaft timing chain · 29 torque figures
- Removing and installing infeed for refrigerant lines in plenum chamber
- Detaching and re-attaching refrigerant lines from front expansion valve
- Removing and installing refrigerant lines from rear expansion valve to evaporator in rear heater and air conditioning unit
- Removing and installing left centre vent control motor V110
- Checking glow plug for heater Q9 · 1 torque figures
Who makes these pages, and how
TorqFix was built by a mechanic — after a 2,700 km drive with five roadside repairs that no diagnostic tool could explain.
The figures on this page come from manufacturer workshop documentation and are shown as they are. The page is assembled automatically from that data — it is not written by an AI. The AI works in the chat, where it answers for your specific car. It writes nothing here.
Variants of the same model differ. Cross-check torque against the factory manual for your engine before final tightening.
Seen a figure that does not match your manual? Write to us — we correct it and note when. support@torqfix.com
The story behind TorqFix →Workshop data on this page last updated 20 Sep 2026.