Removing tank shut-off valve on solenoid valves with securing clip — AUDI
Removing tank shut-off valve on solenoid valves with securing clip on Audi: 5 steps, 1 torque figure, engines BCA, BGU, BSE, BSF.
Workshop procedure for AUDI — the exact step sequence and torque figures, straight from real workshop data.
🧭 Before you start
Fits: VW Caddy III (2K, 2004–2015); platform code 2C0
🔩 Torque settings
Values can differ between engine variants — check the code stamped on your block.
| Torque | Fastener / step |
|---|---|
| 130 Nm (96 lb-ft) | Tighten tank shut-off valve (1) |
ℹ️ Always cross-check the exact figure against your vehicle's factory manual before final tightening — a wrong torque can damage the engine. These values are extracted from workshop data and may not cover every variant or revision.
📐 57 workshop diagrams for BCA
Real factory drawings for this job — timing marks, bolt locations and routing. Locked in the free view.
📋 Procedure
- Carefully remove tank shut-off valve (1) using special wrench T10350.
- Fit new seal (2) on tank shut-off valve (1) and install in fuel tank (3).
- Tighten tank shut-off valve (1) to 130 Nm using special wrench T10350. — 130 Nm (96 lb-ft)
- Install fuel tank.
- Once mechanical shut-off valves are installed, open tank shut-off valves.
Ask TorqFix about your Audi BCA — it answers with the exact sequence for that engine and the workshop drawing for each step. First question is free after a 20-second sign-up, no card.
Ask about your Audi BCA — free → or sign up free to see the drawingsOther AUDI procedures
- Test procedure · 3 torque figures
- F - Re-pressing sender wheel · 3 torque figures
- Removing and installing filling connection · 2 torque figures
- Emptying fuel tank if it is less than 3/4 full · 1 torque figures
- Removing and installing sealing flange (pulley end) – Audi
- Removing and installing toothed belt – Audi · 56 torque figures
- Removing engine – Audi A8 D3 · 41 torque figures
- Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
- Installing engine – Audi A8 D4 · 36 torque figures
- Removing and installing camshaft timing chain · 29 torque figures
Who makes these pages, and how
TorqFix was built by a mechanic — after a 2,700 km drive with five roadside repairs that no diagnostic tool could explain.
The figures on this page come from manufacturer workshop documentation and are shown as they are. The page is assembled automatically from that data — it is not written by an AI. The AI works in the chat, where it answers for your specific car. It writes nothing here.
Variants of the same model differ. Cross-check torque against the factory manual for your engine before final tightening.
Seen a figure that does not match your manual? Write to us — we correct it and note when. support@torqfix.com
The story behind TorqFix →Workshop data on this page last updated 20 Sep 2026.