Removing and installing bench seat / individual seats — AUDI

🧭 Before you start

Fits: platform codes SF, SG

📋 Procedure

1. Operate backrest release mechanism (1).
2. Fold backrest (3) towards front in (direction of arrow).
3. Operate release lever (2) in (direction of arrow B).
4. Move seat to rearmost position.
5. Use a screwdriver to release end cap of right, centre seat rail (1) and pull out upwards.

6. Use a screwdriver to release end cap of right seat rail (2) and pull out upwards.
7. Push cap (1) in (direction of arrow).
8. Remove cap (1) from seat rails (2).
9. Operate release lever (1) in (direction of arrow).
10. Move seat as far forwards as possible.
11. Lift seat upwards out of seat rails.
12. Remove seats from 2nd row .
13. If fitted, remove table module from seat rails.
14. Pull on loop (2) to release bench seat.
15. Move bench seat as far forwards as possible (arrow).
16. Fold backrest forwards.
17. With the aid of a second mechanic lift bench seat out of seat rail.
18. Installation is carried out in reverse order.

Other AUDI procedures

• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures
• Removing and installing fuel filter, vehicles without supplementary fuel pump V393
• Removing and installing rear three-point seat belt, Kombi
• Removing and installing luggage compartment side trim, Multivan, rear, side of vehicle with sliding door
• Removing and installing operating mechanism, with mechanical locking system
• Removing undamaged double cab side window