Removing and installing belt guide (rear) - Saloon: Audi A6/A7 C7
Step-by-step removing and installing belt guide (rear) - Saloon for the Audi A6/A7 C7: 15 steps. What to remove, in what order, and what to check after.
Workshop procedure for AUDI — the exact step sequence and torque figures, straight from real workshop data.
🧭 Before you start
Fits: Audi A6/A7 C7 (4G, 2011–2018); platform code 4X
- Renewed: entire belt guide
Don't miss
- When removing and installing belt guide (4), never turn bolts (2). They have been set by the manufacturer.Renew entire belt guide if damaged. — Press retaining hooks (1) on belt guide upwards and hold.
- Outer belt guide (rear): Unplug electrical connector for rear parking aid warning buzzer H15.
📋 Procedure
- Remove side padding .
- Equipment version with fixed rear seat backrest: Remove fixed rear seat backrest .
- Equipment version with multi-contour seat: Remove multi-contour seat .
- Remove luggage compartment side trim:
- Remove D-pillar trim .
- Remove rear shelf .
- ⚠ When removing and installing belt guide (4), never turn bolts (2). They have been set by the manufacturer.Renew entire belt guide if damaged. — Press retaining hooks (1) on belt guide upwards and hold.
- Lift C-pillar trim (3) slightly and slide belt guide to rear (arrow A) until bolt heads (2) can be disengaged from bracket on body.
- Take out belt guide (4) sideways towards vehicle interior (arrow B).
- Outer belt guide (rear): Unplug electrical connector for rear parking aid warning buzzer H15.
- Thread out belt and detach belt guide.
- Place belt in recess in belt guide (4) and position belt guide on bracket.
- Insert belt guide with bolt heads (2) in guide elements at bracket.
- Press belt guide downwards and at the same time pull it forwards, making bolt heads engage in guide elements.
- Pull belt guide forwards until retaining hook engages audibly.
Other AUDI procedures
- Removing and installing toothed belt – Audi · 56 torque figures
- Removing engine – Audi A8 D3 · 41 torque figures
- Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
- Installing engine – Audi A8 D4 · 36 torque figures
- Removing and installing camshaft timing chain · 29 torque figures
- Removing and installing engine oil cooler (front) – Audi 5.0
- Removing and installing control valve from camshaft control valve 1N205
- Removing and installing radiator - all engine codes except CUKB, CXUA
- Removing and installing intake manifold - engine codes CUKB, CXUA
- Removing and installing charging unit 1 for high-voltage batteryAX4
Who makes these pages, and how
TorqFix was built by a mechanic — after a 2,700 km drive with five roadside repairs that no diagnostic tool could explain.
The figures on this page come from manufacturer workshop documentation and are shown as they are. The page is assembled automatically from that data — it is not written by an AI. The AI works in the chat, where it answers for your specific car. It writes nothing here.
Variants of the same model differ. Cross-check torque against the factory manual for your engine before final tightening.
Seen a figure that does not match your manual? Write to us — we correct it and note when. support@torqfix.com
The story behind TorqFix →Workshop data on this page last updated 20 Sep 2026.