Removing and installing belt guide (front): Audi A6 C6

🧭 Before you start

Fits: Audi A6 C6 (4F, 2004–2011)

Don't miss

• Make sure that the belt (4) can move freely.

📋 Procedure

1. Remove B-pillar trim (top).
2. Remove B-pillar trim (bottom) .
3. Remove spreader rivets (2x).
4. Remove air duct.
5. Unscrew bolts (3).

6. Disengage spring element (arrow A).
7. Slide belt guide (1) down as far as it will go.
8. Disengage retaining hooks (arrow B) out of key-hole opening.
9. Detach belt guide (1).
10. Engage retaining hooks (arrow B) in key-hole opening.
11. Slide belt guide (1) up as far as it will go.
12. Screw in bolts (3) (2x) and tighten to specified torque.
13. Make sure that the belt (4) can move freely.

Other AUDI procedures

• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures
• Removing and installing lower wishbone and mounting bracket · 1 torque figures
• Removing and installing drive shaft with triple roller joint AAR 3300i (with external splines for insertion in gearbox)
• Renewing sensor wiring – Audi TT Mk2
• Removing and installing brake master cylinder (all vehicles except TT RS)
• Removing and installing gearbox housing cover and 5th/6th gear