Removing and installing backrest of individual seat in 2nd row, Multivan/Business — AUDI

🧭 Before you start

Fits: VW Transporter T5 (7H), VW Transporter T5 (7J), VW Transporter T6 (7E), VW Transporter T6 (7F)

📋 Procedure

1. Remove front seat frame trim of individual seat in 2nd row .
2. Remove rear seat frame trim of individual seat in 2nd row .
3. Remove right seat frame trim of individual seat in 2nd row .
4. Remove left seat frame trim of individual seat in 2nd row .
5. Remove seat belt end fitting .

6. Using a small screwdriver, unclip Bowden cable (4) from relay lever (6).
7. Unhook tensioning spring (5).
8. Using a small screwdriver, lever off spring clip (7).
9. Remove relay lever (6) from backrest frame.
10. Remove relay lever (8) from backrest frame.
11. Unscrew bolts (3) (Qty. 2).
12. Unscrew bolt (1) and remove backrest (2) upwards from seat frame. [Note: Bolts (1) and (3) are microencapsulated. They must be renewed each time after loosening.Before new bolts are installed, the threads of the corresponding holes must be cleaned.Spring clip (7) is destroyed during removal and must be renewed.]

Other AUDI procedures

• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures
• Checking activation of electric supplementary air heater
• Removing and installing motor for rear lid V444/V445 - Avant
• Calibrating matrix LED headlights with headlight adjustment unit VAS 621001
• Removing and installing oil pressure and oil temperature sender G437 or oil pressure and oil temperature sender 2 G640, 0BE, 0BF
• Removing and installing knock sensor 4 G199 - vehicles up to model year 2013