Removing and installing ATF cooler, 5-cylinder diesel engine — AUDI

🧭 Before you start

Fits: VW Transporter T5 (7H)

• Opens: brake fluid

Don't miss

• Remove ATF lines (1) from ATF cooler. When doing this, counterhold on union hexagon flats (2).
• Fit ATF lines (1) to ATF cooler. When doing this, counterhold on union hexagon flats (2).

📋 Procedure

1. ⚠ Please observe the following points during all installation work, in particular in the engine compartment, due to the space limitations:Route all kinds of lines (e.g. for fuel, hydraulics, activated charcoal system, coolant and refrigerant, brake fluid, vacuum) and electrical cables so that the original line routing is re-established.Make sure there is adequate clearance from all moving or hot parts. — Remove noise insulation beneath engine General body repairs, exterior66Exterior equipment; Noise insulation.
2. Place drip trayV.A.G 1306 underneath.
3. Seal coolant lines (arrows) with hose clamps, up to 25 mm in diameter3094, and remove them from ATF cooler using hose clip pliersV.A.G 1921.
4. Remove ATF lines (1) from ATF cooler. When doing this, counterhold on union hexagon flats (2).
5. Remove bolts (1) and remove ATF cooler (2).

6. If necessary, remove bolts (arrows) and remove bracket for ATF cooler from subframe.
7. Tighten bolts (arrows) for ATF cooler bracket on subframe.
8. Tighten bolts (1) for ATF cooler (2).
9. Remove hose clamps, up to 25 mm in diameter3094 from coolant lines (arrows).
10. Fit ATF lines (1) to ATF cooler. When doing this, counterhold on union hexagon flats (2).
11. Check ATF level .

Other AUDI procedures

• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures
• Removing and installing coolant pipes (at side) – Audi 2.0
• Removing and installing engine oil cooler on lock carrier
• Removing and installing side airbag (front) with airbag igniter
• Removing and installing sill panel trim (rear) – Audi Q5
• Removing and installing rear lid trim (bottom) - Saloon – Audi