Removing and installing alternator - 2.0 l petrol engine — AUDI

🧭 Before you start

Fits: VW Transporter T5 (7H), VW Transporter T5 (7J), VW Transporter T6 (7E), VW Transporter T6 (7F)

📋 Procedure

1. ⚠ To disconnect and reconnect the battery, the procedure described in the workshop manual should be strictly adhered to . — Disconnect battery .
2. Release and disconnect electrical connector of DF cable (1) and pull off protective cap (2).
3. Unbolt battery positive cable (arrow) from alternator.
4. Remove poly V-belt Power unit13Cylinder block, belt pulley end; Removing and installing poly V-belt.
5. Remove tensioning element for poly V-belt Power unit13Cylinder block, belt pulley end; Removing and installing poly V-belt tensioner.

6. Undo bolts securing alternator (arrows).
7. Remove alternator.
8. ⚠ When fitting used poly V-belts, take note of the direction of rotation as marked during removal!Before installing poly V-belt, ensure that all ancillaries (alternator, air conditioner compressor) are secure.When fitting belt, ensure that poly V-belt seats correctly in pulleys! — Drive threaded sleeves (A) about 4 mm in direction of arrow out of alternator housing.
9. Fit alternator to bracket and tighten securing bolts.
10. Tighten threaded connections to specified torques Assembly overview - alternator, 2.0 l petrol engine.
11. Install poly V-belt and tensioning element Power unit13Cylinder block, belt pulley end;.
12. On V6 petrol engine, unscrew thrust bolt M8×50 from belt tensioner.
13. Connecting battery .
14. Start engine and check belt running.

Other AUDI procedures

• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures
• Removing and installing engine oil cooler – Audi TT Mk2
• Removing and installing exhaust gas temperature sender 3G495 · 1 torque figures
• Checking return flow rate of injectors at starter cranking speed
• Removing and installing engine control unit J623 – Audi
• Renewing oil seal (left-side) – Audi Q7