Removing and installing 4-spoke steering wheel: Audi A3
Step-by-step removing and installing 4-spoke steering wheel for the Audi A3: 14 steps. What to remove, in what order, and what to check after.
Workshop procedure for AUDI — the exact step sequence and torque figures, straight from real workshop data.
🧭 Before you start
Fits: Audi A3 (8P, 2003–2012)
Don't miss
- If the steering wheel you are removing is to be re-installed, mark position of steering wheel in relation to steering column.
- Make sure wiring in steering wheel is routed correctly
📋 Procedure
- ⚠ Observe safety regulations for pyrotechnic components . — Remove airbag unit (7):
- Release connector for contact unit (5).
- Unplug connector of contact unit (5) from contact unit at return ring with slip ring (1).
- Turn steering wheel to centre position (wheels in straight-ahead position).
- Unscrew multi-point socket head bolt (9).
- If the steering wheel you are removing is to be re-installed, mark position of steering wheel in relation to steering column.
- Detach steering wheel (2).
- Attach steering wheel (2):
- Screw in new multi-point socket head bolt (9) and tighten to specified torque. [Note: Make sure wiring in steering wheel is routed correctly]
- Plug connector of contact unit (5) into contact unit at return ring with slip ring (1).
- Lock connector of contact unit (5) in position.
- Install airbag unit (7): steering wheel without multi-function feature and without tiptronic , steering wheel with multi-function feature and tiptronic .
- Perform test drive.
- If steering wheel is not straight, remove it again and adjust it on steering column splines.
Other AUDI procedures
- Removing and installing toothed belt – Audi · 56 torque figures
- Removing engine – Audi A8 D3 · 41 torque figures
- Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
- Installing engine – Audi A8 D4 · 36 torque figures
- Removing and installing camshaft timing chain · 29 torque figures
- Removing and installing right vent temperature sender G151
- Removing engine cover panel – Audi A3 1.6
- Removing and installing gearbox input speed sender G182/clutch temperature sender G509
- Removing circulation pump V55 – Audi A3
- Checking charge air system for leaks, engines with code letters AXX, BPY, BWA
Who makes these pages, and how
TorqFix was built by a mechanic — after a 2,700 km drive with five roadside repairs that no diagnostic tool could explain.
The figures on this page come from manufacturer workshop documentation and are shown as they are. The page is assembled automatically from that data — it is not written by an AI. The AI works in the chat, where it answers for your specific car. It writes nothing here.
Variants of the same model differ. Cross-check torque against the factory manual for your engine before final tightening.
Seen a figure that does not match your manual? Write to us — we correct it and note when. support@torqfix.com
The story behind TorqFix →Workshop data on this page last updated 20 Sep 2026.