Poly V-belt - exploded view — AUDI
Poly V-belt - exploded view on Audi: 3 steps, 1 torque figure, engines BPJ, BYK. What to remove, what to tighten and to how many Nm, what to check after.
Workshop procedure for AUDI — the exact step sequence and torque figures, straight from real workshop data.
🧭 Before you start
Fits: Audi A6 C6 (4F, 2004–2011)
🔩 Torque settings
Values can differ between engine variants — check the code stamped on your block.
| Torque | Fastener / step |
|---|---|
| 40 Nm (30 lb-ft) | Tighten bolts |
ℹ️ Always cross-check the exact figure against your vehicle's factory manual before final tightening — a wrong torque can damage the engine. These values are extracted from workshop data and may not cover every variant or revision.
📐 30 workshop diagrams for BPJ
Real factory drawings for this job — timing marks, bolt locations and routing. Locked in the free view.
📋 Procedure
- Apply locking fluid and tighten bolts in the sequence (1 ... 6) in 2 stages as follows.
- Tighten bolts hand tight.
- Tighten bolts to 40 Nm. — 40 Nm (30 lb-ft)
Ask TorqFix about your Audi BPJ — it answers with the exact sequence for that engine and the workshop drawing for each step. First question is free after a 20-second sign-up, no card.
Ask about your Audi BPJ — free → or sign up free to see the drawingsOther AUDI procedures
- Checking fuel pump control unit J538 - vehicles with FSI engine
- Removing and installing fuel pump control unit J538
- Removing and installing fuel pump control unit J538 - vehicles with FSI engine from 06.2004 onwards
- Checking fuel pump control unit J538 - vehicles with 4-cylinder TFSI engine
- Intake manifold - exploded view
- Removing and installing toothed belt – Audi · 56 torque figures
- Removing engine – Audi A8 D3 · 41 torque figures
- Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
- Installing engine – Audi A8 D4 · 36 torque figures
- Removing and installing camshaft timing chain · 29 torque figures
Who makes these pages, and how
TorqFix was built by a mechanic — after a 2,700 km drive with five roadside repairs that no diagnostic tool could explain.
The figures on this page come from manufacturer workshop documentation and are shown as they are. The page is assembled automatically from that data — it is not written by an AI. The AI works in the chat, where it answers for your specific car. It writes nothing here.
Variants of the same model differ. Cross-check torque against the factory manual for your engine before final tightening.
Seen a figure that does not match your manual? Write to us — we correct it and note when. support@torqfix.com
The story behind TorqFix →Workshop data on this page last updated 20 Sep 2026.