Part II: Balance shaft assembly with oil pump - exploded view — AUDI
Part II: Balance shaft assembly with oil pump - exploded view on Audi: 4 steps, 1 torque figure, engines BGB, BPG, BPJ, BUL.
Workshop procedure for AUDI — the exact step sequence and torque figures, straight from real workshop data.
🧭 Before you start
Fits: Audi A4 Cabriolet B6/B7 (8H), Audi A4 B6/B7 (8E)
🔩 Torque settings
Values can differ between engine variants — check the code stamped on your block.
| Torque | Fastener / step |
|---|---|
| 15 Nm (11 lb-ft) | Tighten bolts |
ℹ️ Always cross-check the exact figure against your vehicle's factory manual before final tightening — a wrong torque can damage the engine. These values are extracted from workshop data and may not cover every variant or revision.
📋 Procedure
- Tighten bolts (arrows) in 3 stages as follows, working from the inside outwards:
- Tighten bolts hand-tight.
- Tighten bolts to 15 Nm. — 15 Nm (11 lb-ft)
- Turn bolts 90° further.
Other AUDI procedures
- Valve gear - exploded view · 4 torque figures
- Removing and installing suction-jet pump in left fuel tank chamber
- Part I: Sump, balance shaft assembly - exploded view · 4 torque figures
- Renewing crankshaft oil seal - pulley end – Audi A6 C6 · 2 torque figures
- Removing and installing intake manifold with fuel rail
- Removing and installing toothed belt – Audi · 56 torque figures
- Removing engine – Audi A8 D3 · 41 torque figures
- Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
- Installing engine – Audi A8 D4 · 36 torque figures
- Removing and installing camshaft timing chain · 29 torque figures
Who makes these pages, and how
TorqFix was built by a mechanic — after a 2,700 km drive with five roadside repairs that no diagnostic tool could explain.
The figures on this page come from manufacturer workshop documentation and are shown as they are. The page is assembled automatically from that data — it is not written by an AI. The AI works in the chat, where it answers for your specific car. It writes nothing here.
Variants of the same model differ. Cross-check torque against the factory manual for your engine before final tightening.
Seen a figure that does not match your manual? Write to us — we correct it and note when. support@torqfix.com
The story behind TorqFix →Workshop data on this page last updated 20 Sep 2026.