IV - Adjusting 2nd and 4th gear brake -B2- — AUDI

🧭 Before you start

Fits: platform code 8G

Don't miss

• The clutch pack for -B2- is now pressed together for the measurements.

🔩 Torque settings

Values can differ between engine variants — check the code stamped on your block.

ℹ️ Always cross-check the exact figure against your vehicle's factory manual before final tightening — a wrong torque can damage the engine. These values are extracted from workshop data and may not cover every variant or revision.

📋 Procedure

1. Apply setting tool3459 to the last inner plate and turn so that the 3 clips align with the holes for the ATF pump.
2. Bolt special tool to flange for ATF pump: tightening torque 5 Nm. [Note: The clutch pack for -B2- is now pressed together for the measurements.] — 5 Nm (3.7 lb-ft)
3. Measure from pump flange/gearbox housing (arrow) to setting tool3459 with depth gauge.
4. Detach setting tool3459.
5. Push piston into ATF pump onto stop.

6. Fit paper gasket onto ATF Pump.
7. Place straightedge (B) on bottom of stator support (arrows) and use depth gauge (A) to measure to pump flange gasket.
8. Determine outer plate(s) according to table . Part Nos. Electronic parts catalogue.
9. Fit three spring caps on compression springs.
10. Install last outer plate(s) of the required thickness.
11. Install corrugated washer.
12. Further procedure for assembly .

Other AUDI procedures

• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures
• Removing and installing operating and display unit -E87
• Checking air conditioner refrigeration capacity
• Removing and installing air conditioner (complete)
• Removing and installing power-assisted steering box for LHD vehicles with V8 TDI engine
• Testing cooling capacity of air conditioner