Installing front interior light W1 with warning lamp for airbag deactivated on front passenger side — AUDI

🧭 Before you start

Fits: Audi A4 Cabriolet B6/B7 (8H), Audi A2 (8Z), Audi A3 (8L, 1996–2003), Audi A4 B5 (8D), Audi A4 B6/B7 (8E), Audi A6 C5 (4B), Audi A8 D2 (4D), Audi A8 D3 (4E, 2002–2010), Audi A3 (8P, 2003–2012), Audi TT Mk1 (8N), Audi A6 C6 (4F, 2004–2011)

Don't miss

• Plug in connectors to front interior light W1(1) and warning lamp for airbag deactivated on front passenger side K145.
• Make sure nobody is in the vehicle when the battery is being connected. — Connect battery earth strap Electrical system27.

📋 Procedure

1. Plug in connectors to front interior light W1(1) and warning lamp for airbag deactivated on front passenger side K145.
2. Install front interior light W1(1) with cover panel (2).
3. Switch on ignition.
4. ⚠ Make sure nobody is in the vehicle when the battery is being connected. — Connect battery earth strap Electrical system27.
5. Observe measures to be taken after connecting the battery Electrical system27.

6. Re-code airbag control unit J234.
7. Perform functional test.
8. Deactivate airbag on front passenger side with key-operated switch to deactivate airbag on front passenger side E224.
9. Activate airbag on front passenger side with key-operated switch to deactivate airbag on front passenger side E224.
10. Interrogate and erase fault memories of all control units. To do so, use a suitable vehicle diagnostic, testing and information system, e.g. vehicle diagnostic, testing and information systemVAS 5051B.

Other AUDI procedures

• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures
• Electrical check of exhaust gas recirculation valve -N18 and potentiometer for exhaust gas recirculation -G212
• Checking boost pressure - engine code AGR – Audi 1.9 TDI
• Checking accelerator pedal position sender – Audi 1.6 BAH
• Removing and installing control until and hydraulic unit
• Checking lambda probe and lambda regulation after catalytic converter