Flywheel - exploded view — AUDI
Flywheel - exploded view on Audi: 3 steps, 1 torque figure, engines BDX, CJBA. What to remove, what to tighten and to how many Nm, what to check after.
Workshop procedure for AUDI — the exact step sequence and torque figures, straight from real workshop data.
🧭 Before you start
Fits: Audi A8 D3 (4E, 2002–2010)
🔩 Torque settings
Values can differ between engine variants — check the code stamped on your block.
| Torque | Fastener / step |
|---|---|
| 22 Nm (16 lb-ft) | Tighten in diagonal sequence |
ℹ️ Always cross-check the exact figure against your vehicle's factory manual before final tightening — a wrong torque can damage the engine. These values are extracted from workshop data and may not cover every variant or revision.
📐 30 workshop diagrams for BDX
Real factory drawings for this job — timing marks, bolt locations and routing. Locked in the free view.
📋 Procedure
- Tighten bolts (1) for damper unit (A) in two stages as follows:
- Screw in by hand until contact is made.
- Tighten in diagonal sequence to 22 Nm. — 22 Nm (16 lb-ft)
Ask TorqFix about your Audi BDX — it answers with the exact sequence for that engine and the workshop drawing for each step. First question is free after a 20-second sign-up, no card.
Ask about your Audi BDX — free → or sign up free to see the drawingsOther AUDI procedures
- Checking fuel system diagnostic pump V144 - vehicles with FSI engine
- Removing and installing radiator fans
- Removing and installing accelerator pedal module with accelerator position sender
- Removing and installing fuel gauge sender 4 G393 (tubular sender, right-side)
- Removing and installing oil pressure switch for reduced oil pressure F378
- Removing and installing toothed belt – Audi · 56 torque figures
- Removing engine – Audi A8 D3 · 41 torque figures
- Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
- Installing engine – Audi A8 D4 · 36 torque figures
- Removing and installing camshaft timing chain · 29 torque figures
Who makes these pages, and how
TorqFix was built by a mechanic — after a 2,700 km drive with five roadside repairs that no diagnostic tool could explain.
The figures on this page come from manufacturer workshop documentation and are shown as they are. The page is assembled automatically from that data — it is not written by an AI. The AI works in the chat, where it answers for your specific car. It writes nothing here.
Variants of the same model differ. Cross-check torque against the factory manual for your engine before final tightening.
Seen a figure that does not match your manual? Write to us — we correct it and note when. support@torqfix.com
The story behind TorqFix →Workshop data on this page last updated 20 Sep 2026.