Exploded view - convertible roof cover, convertible roof headliner, trim (front) — AUDI
Exploded view - convertible roof cover, convertible roof headliner, trim (front) on Audi: 4 steps, 4 torque figures.
Workshop procedure for AUDI — the exact step sequence and torque figures, straight from real workshop data.
🧭 Before you start
Fits: platform code 42
🔩 Torque settings
Values can differ between engine variants — check the code stamped on your block.
| Torque | Fastener / step |
|---|---|
| 5.5 Nm (4.1 lb-ft) | Tighten bolt (1) |
| 5.5 Nm (4.1 lb-ft) | Tighten bolt (4) |
| 5.5 Nm (4.1 lb-ft) | Tighten bolts (2, 6 and 7) |
| 5.5 Nm (4.1 lb-ft) | Tighten bolts (arrows) |
ℹ️ Always cross-check the exact figure against your vehicle's factory manual before final tightening — a wrong torque can damage the engine. These values are extracted from workshop data and may not cover every variant or revision.
📋 Procedure
- Tighten bolts (arrows) to 5.5 Nm. — 5.5 Nm (4.1 lb-ft)
- Tighten bolts (2, 6 and 7) to 5.5 Nm. — 5.5 Nm (4.1 lb-ft)
- Tighten bolt (4) to 5.5 Nm. — 5.5 Nm (4.1 lb-ft)
- Tighten bolt (1) to 5.5 Nm. — 5.5 Nm (4.1 lb-ft)
Other AUDI procedures
- Removing and installing toothed belt – Audi · 56 torque figures
- Removing engine – Audi A8 D3 · 41 torque figures
- Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
- Installing engine – Audi A8 D4 · 36 torque figures
- Removing and installing camshaft timing chain · 29 torque figures
- Checking vacuum hose to vacuum unit on turbocharger
- Checking vacuum hose to vacuum unit on exhaust gas recirculation cooler
- Removing and installing gearbox hydraulic pressure sender V387
- Removing and installing main switch for Start/Stop system
- Removing and installing power latching motor V329 on high sliding doors with additional lock
Who makes these pages, and how
TorqFix was built by a mechanic — after a 2,700 km drive with five roadside repairs that no diagnostic tool could explain.
The figures on this page come from manufacturer workshop documentation and are shown as they are. The page is assembled automatically from that data — it is not written by an AI. The AI works in the chat, where it answers for your specific car. It writes nothing here.
Variants of the same model differ. Cross-check torque against the factory manual for your engine before final tightening.
Seen a figure that does not match your manual? Write to us — we correct it and note when. support@torqfix.com
The story behind TorqFix →Workshop data on this page last updated 20 Sep 2026.