Dismantling and assembling reverse gear output shaft — AUDI

🧭 Before you start

Fits: VW Transporter T5 (7H), VW Transporter T5 (7J), VW Transporter T6 (7E), VW Transporter T6 (7F)

• Special tools named: puller

Don't miss

• If internal puller slips out of hole in dished washer, use next larger size of internal puller.
• Position tubeVW 463/2 so that ribs on housing (arrow) will not be damaged.

📋 Procedure

1. Position sleeve of removing and installing toolVW 459/1 over bearing seat with shoulder facing counter support(A).
2. First insert oil deflector and shim.
3. Support clutch housing with thrust pieceVW 473 directly below bearing support. [Note: If internal puller slips out of hole in dished washer, use next larger size of internal puller.]
4. Place thrust piece3401 with collar (arrow) on dished washer (A).
5. First remove circlip.

6. Before setting up pulling device, set press toolVW 431 on output shaft.
7. Locate reverse gear synchromeshed gear with needle and roller bearings on output shaft.
8. Press on reverse gear synchro-hub.
9. Install circlip.
10. Position thrust piece3118 over bearing seat with shoulder facing counter support(A).
11. First lay shim beneath outer race.
12. Support gearbox housing with tubeVW 463/2 directly below bearing support. [Note: Position tubeVW 463/2 so that ribs on housing (arrow) will not be damaged.]

Other AUDI procedures

• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures
• Removing and installing timing chain cover (top) - vehicles with engine codes CJSA, CJSB, CJXB, CJXC, CJXF, CYFB
• Removing and installing lock carrier - Audi RS 3 – Audi A3
• Removing and installing trim panel for A-pillar · 1 torque figures
• Removing and installing selector unit with gearbox installed
• Removing and installing actuator for engine temperature regulation N493