TorqFix

Detaching fuel rail from intake manifold — AUDI

Detaching fuel rail from intake manifold on Audi: 10 steps, engines BPU, BYT, BZB, CAWB. What to remove, in what order, and what to check after.

Workshop procedure for AUDI — the exact step sequence and torque figures, straight from real workshop data.

10 steps 8 engine codes engine codes merged from 2 documented variants

🧭 Before you start

Fits: Audi A3 (8P, 2003–2012)

  • Opens: fuel

Don't miss

  • Always renew both connecting pieces for fuel supply line.

🔧 Engine codes this applies to

BPUBYTBZBCAWBCBFACCTACCZACDAA

📋 Procedure

  1. Release hose clip (1).
  2. Remove hoses from activated charcoal filter.
  3. Disconnect fuel pipe at fuel rail.
  4. Unscrew two bolts (arrows) on fuel rail.
  5. Detach fuel rail from intake manifold.
BPU? Steps differ between engine variants — check this job against your exact car before you commit to it. Check my car — free →
  1. Always renew both connecting pieces for fuel supply line.
  2. Connect fuel pipe.
  3. Re-connect electrical connectors.
  4. Install intake manifold .
  5. The remaining installation steps are carried out in the reverse sequence.

Other AUDI procedures

Who makes these pages, and how

TorqFix was built by a mechanic — after a 2,700 km drive with five roadside repairs that no diagnostic tool could explain.

The figures on this page come from manufacturer workshop documentation and are shown as they are. The page is assembled automatically from that data — it is not written by an AI. The AI works in the chat, where it answers for your specific car. It writes nothing here.

Variants of the same model differ. Cross-check torque against the factory manual for your engine before final tightening.

Seen a figure that does not match your manual? Write to us — we correct it and note when. support@torqfix.com

The story behind TorqFix →

Workshop data on this page last updated 20 Sep 2026.