Checking gear oil in bevel box — AUDI
Checking gear oil in bevel box on Audi: 7 steps, 1 torque figure. What to remove, what to tighten and to how many Nm, what to check after.
Workshop procedure for AUDI — the exact step sequence and torque figures, straight from real workshop data.
🧭 Before you start
Fits: VW Transporter T6 (7E)
🔩 Torque settings
Values can differ between engine variants — check the code stamped on your block.
| Torque | Fastener / step |
|---|---|
| 10 Nm (7.4 lb-ft) | Tighten oil filler plug (arrow) |
ℹ️ Always cross-check the exact figure against your vehicle's factory manual before final tightening — a wrong torque can damage the engine. These values are extracted from workshop data and may not cover every variant or revision.
📋 Procedure
- If fitted, remove noise insulation General body repairs, exterior66Noise insulation; Assembly overview - noise insulation.
- Remove oil filler plug (arrow).
- Tighten oil filler plug (arrow) to 10 Nm. — 10 Nm (7.4 lb-ft)
- Remove oil filler plug (arrow).
- Using filling device for Haldex coupling 2VAS 6291, add enough oil so that it runs out between the adapter of the filling device and the final drive housing.
- Tighten oil filler plug (arrow) to 10 Nm. — 10 Nm (7.4 lb-ft)
- If present, install noise insulation General body repairs, exterior66Noise insulation; Assembly overview - noise insulation.
Other AUDI procedures
- Removing and installing toothed belt – Audi · 56 torque figures
- Removing engine – Audi A8 D3 · 41 torque figures
- Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
- Installing engine – Audi A8 D4 · 36 torque figures
- Removing and installing camshaft timing chain · 29 torque figures
- Removing and installing fuel pump control unit J538 - vehicles with FSI engine from 06.2004 onwards
- Checking fuel system diagnostic pump V144 - vehicles with 8-cylinder MPI engine
- Checking fuel system diagnostic pump V144 - vehicles with FSI engine
- Removing and installing selector lever cable (vehicles up to 11.2005)
- Removing and installing bracket for knee bolster – Audi A6 C6
Who makes these pages, and how
TorqFix was built by a mechanic — after a 2,700 km drive with five roadside repairs that no diagnostic tool could explain.
The figures on this page come from manufacturer workshop documentation and are shown as they are. The page is assembled automatically from that data — it is not written by an AI. The AI works in the chat, where it answers for your specific car. It writes nothing here.
Variants of the same model differ. Cross-check torque against the factory manual for your engine before final tightening.
Seen a figure that does not match your manual? Write to us — we correct it and note when. support@torqfix.com
The story behind TorqFix →Workshop data on this page last updated 20 Sep 2026.