Brake system — Checking electric vacuum pump for brakes V192 — AUDI

🧭 Before you start

Fits: Audi A6 C6 (4F, 2004–2011)

📋 Procedure

1. With ignition switched off, connect vehicle diagnostic, testing and information systemVAS 5051 to diagnostic connection with diagnosis leadVAS 5051/1 or diagnosis leadVAS 5051/3.
2. Switch on the tester (arrow).
3. Switch on ignition.
4. Select mode: Press the button on the display for "“Vehicle self-diagnosis”".
5. Select vehicle system in display: "“Engine electronics”".

6. Select diagnosis function (all diagnosis functions are available at this stage).
7. Select "“006 - Basic setting”" on the display.
8. Press buttons 0, 1 and 1 for Measured value block.
9. Confirm entry with Q key.
10. Firmly depress the brake pedal several times in succession until the test is activated.
11. You can cancel or exit from this mode by pressing the Go to button.
12. Follow "“Guided Fault Finding”" procedure using vehicle diagnostic, testing and information systemVAS 5051.

Other AUDI procedures

• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures
• Removing and installing power steering pump (vehicles with 8-cylinder petrol engine)
• Removing and installing brake pads (PR 1LJ, 1LL) – Audi A6 C6 · 1 torque figures
• Removing and installing front brake pads (RS 6) – Audi A6 C6 · 1 torque figures
• Removing and installing actuator motor for electronic parking brake and handbrake · 1 torque figures
• Removing and installing radioR, MMI (up to week 35/08) – Audi · 2 torque figures