Automatic gearbox 01M — Checking gear oil level in final drive — AUDI
Automatic gearbox 01M — Checking gear oil level in final drive on Audi: 11 steps. What to remove, in what order, and what to check after.
Workshop procedure for AUDI — the exact step sequence and torque figures, straight from real workshop data.
🧭 Before you start
Fits: Audi A3 (8L, 1996–2003)
- Opens: gearbox oil
- Renewed: seal
Don't miss
- Check gear oil level at drive for speedometer sender G22.
- The gear oil quantity between "“Min”" and "“Max”" is 0.1 litre.Excess gear oil can be drawn off with used oil collection and extraction unitV.A.G 1782.
- Renew seal on plug.
📋 Procedure
- Carry out a short test drive in order to heat gear oil to approx. 60 °C.
- Drive vehicle onto a lifting platform or over an inspection pit in order for it to be absolutely horizontal.
- Switch off engine and let gear oil drip into gearbox housing for 5 minutes. [Note: Check gear oil level at drive for speedometer sender G22.]
- Remove drive for speedometer sender at top of gearbox (arrow) and clean with cloth.
- Install drive for speedometer sender and remove again, check gear oil level. [Note: The gear oil quantity between "“Min”" and "“Max”" is 0.1 litre. Excess gear oil can be drawn off with used oil collection and extraction unit V.A.G 1782.]
- Top up gear oil as necessary; specification (see the separate procedure).
- Install drive for speedometer sender G22.
- Remove plug (1).
- Check the oil level with a suitable improvised tool, e.g. bent wire.
- Top up gear oil as necessary; specification (see the separate procedure). [Note: Renew seal on plug.]
- Tighten plug.
Other AUDI procedures
- Removing and installing toothed belt – Audi · 56 torque figures
- Removing engine – Audi A8 D3 · 41 torque figures
- Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
- Installing engine – Audi A8 D4 · 36 torque figures
- Removing and installing camshaft timing chain · 29 torque figures
- Adjusting CO2 level in additional heater exhaust gas (heater with no recirculating pump -V55)
- Servicing steering column switch
- Dismantling and assembling electric window lifters
- Checking current supply relay for Digifant control unit -J176
- Removing and installing thrust tube
Who makes these pages, and how
TorqFix was built by a mechanic — after a 2,700 km drive with five roadside repairs that no diagnostic tool could explain.
The figures on this page come from manufacturer workshop documentation and are shown as they are. The page is assembled automatically from that data — it is not written by an AI. The AI works in the chat, where it answers for your specific car. It writes nothing here.
Variants of the same model differ. Cross-check torque against the factory manual for your engine before final tightening.
Seen a figure that does not match your manual? Write to us — we correct it and note when. support@torqfix.com
The story behind TorqFix → · How these pages are made →Workshop data on this page last updated 20 Sep 2026.