Assembly overview - poly-V belt drive on vehicles without A/C system — AUDI

🧭 Before you start

Fits: VW Transporter T6 (7F), VW Transporter T6 (7E)

🔧 Engine codes this applies to

🔩 Torque settings

Values can differ between engine variants — check the code stamped on your block.

ℹ️ Always cross-check the exact figure against your vehicle's factory manual before final tightening — a wrong torque can damage the engine. These values are extracted from workshop data and may not cover every variant or revision.

📐 31 workshop diagrams for CAAA

Real factory drawings for this job — timing marks, bolt locations and routing. Locked in the free view.

📋 Procedure

1. Insert bolts for ancillary bracket as follows:
2. Tighten bolts for ancillary bracket in sequence (1 … 6) in 2 stages as follows:
3. Screw all bolts in to stop by hand.
4. Tighten all bolts to 40 Nm. — 40 Nm (30 lb-ft)
5. Turn bolts (1, 2, 5 and 6) 90° further.
6. Turn bolts (3) and (4) 180° further.

Other AUDI procedures

• Assembly overview - sump/oil pump, vehicles with balancer shaft module
• Checking vacuum hoses and vacuum switch for rear differential lock F363
• Checking low pressure on high-pressure pump, engines with supplementary fuel pump V393
• Removing and installing Hall sender G40
• Removing and installing tandem pump, engine codes AXD, AXE, BLJ, BNZ, BPC
• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures