Assembly overview - drive chain for balance shaft — AUDI

🧭 Before you start

Fits: platform codes SF, SG

• Special tools named: torque wrench

🔧 Engine codes this applies to

🔩 Torque settings

Values can differ between engine variants — check the code stamped on your block.

ℹ️ Always cross-check the exact figure against your vehicle's factory manual before final tightening — a wrong torque can damage the engine. These values are extracted from workshop data and may not cover every variant or revision.

📐 23 workshop diagrams for CJKA

Real factory drawings for this job — timing marks, bolt locations and routing. Locked in the free view.

📋 Procedure

1. Tighten as follows using new bolt.
2. Tighten with torque wrench initially to 10 Nm. — 10 Nm (7.4 lb-ft)
3. Turn intermediate shaft sprocket.
4. Tighten with torque wrench to 25 Nm. — 25 Nm (18 lb-ft)
5. Use fixed wrench to turn 90° further.

Other AUDI procedures

• Removing and installing toothed belt for coolant pump – Audi
• Removing and installing air filter housing – Audi 2.0 TDI
• Removing and installing engine mounting – Audi 2.0 TDI
• Removing and installing fuel tank, engine codes AXA, BDL, BKK
• Removing and installing Lambda probe after catalytic converter G130
• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures