6-speed manual gearbox 0AG — Checking oil level in manual gearbox — AUDI

🧭 Before you start

Fits: Audi A3 (8P, 2003–2012)

• Also covered elsewhere: Electronic parts catalogue

Don't miss

• Drive vehicle onto a four-column lifting platform or over an inspection pit (vehicle must be horizontal).

📋 Procedure

1. Drive vehicle onto a four-column lifting platform or over an inspection pit (vehicle must be horizontal).
2. Remove centre noise insulation (fasteners 1 ... 3).
3. Remove oil filler plug (arrow).
4. Top up gear oil if necessary. For gear oil specification, refer to Electronic parts catalogue.
5. Tighten oil filler plug to specified torque.

6. Install noise insulation.
7. Fill up gear oil to bottom lip of filler hole.
8. Screw in oil filler plug.
9. Start engine, engage a gear and allow gearbox to turn for approx. 2 minutes.
10. Switch off engine and remove oil filler plug.
11. Top up gear oil again to bottom lip of filler hole.
12. Tighten oil filler plug to specified torque.
13. Install noise insulation.

Other AUDI procedures

• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures
• Removing and installing clutch module – Audi A5 / A4 B8
• Checking fuel delivery rate - vehicles with 3.0 ltr. TFSI engine
• Checking delivery rate of fuel pump G6 - 4-cylinder and 6-cylinder engines (generation II) and 4-cylinder EA 288 engines (generation I)
• Removing and installing gas discharge bulb L13/L14 - up to model year 2012
• Removing and installing printed circuit board – Audi Q5