RENAULT Z7U-702 — 2.5L Engine
2.5L · 181 hp
Engine overview
Vehicles with this engine
Factory specifications
Values from the manufacturer documentation for this engine.
Engine (general)
| Engine code | Z7U-702 |
| Capacity | 2458 cc |
| Idle speed | 700 ± 50 rpm |
| Inlet | 0.10 mm |
| Exhaust | 0.25 mm |
| Normal | 8.6 bar |
| Oil pressure | 4.4/4000 bar/rpm |
Engine (petrol)
| Fuel system (make and type) | Renix R |
| Number of cylinders | 6 |
| Firing order | 1-6-3-5-2-4 |
| Ignition coil resistance, primary | 0.4 - 0.8 ohms |
| Ignition coil resistance, secondary | 2000 - 12000 ohms |
| Spark plugs (make and type) | Eyquem 805LJSP |
| Spark plug gap | 0.65 mm |
| Fuel pump pressure | 3.0 bar |
| Injection pressure/system pressure | 2.5 ± 0.2 bar |
| CO exhaust gas | 1.5 ± 0.5 % |
| CO2 | 13 - 16 % |
| HC | 300 ppm |
| O2 | 0.5 - 2.0 % |
Cooling system
| Cap pressure | 0.8/1.6 bar |
| Thermostat opens at | 86 °C |
Electrical
| Battery | 55 Ah |
| Alternator | 90 105 A |
Capacities
| Engine sump, incl. filter | 8.0 l |
| Gearbox refill | 3.0 l |
| Cooling system | 9.7 l |
Torque settings
| Cylinder head bolts — Stage 1 | 60 Nm |
| Cylinder head bolts — Stage 3 | 360 ° |
| Cylinder head bolts — Stage 4 | 20 Nm |
| Cylinder head bolts — Stage 5 | 127 ° |
| Cylinder head bolts — Stage 6 | [НЕ е една стойност — зависи от изпълнението] T = 86°C+ t = 360 min |
| Cylinder head bolts — Stage 7 | 25 ° |
| Front hub | 250 Nm |
| Rear hub | 160 Nm |
| Wheel nuts | 100 Nm |
| Spark plugs | 17 - 20 Nm |
Workshop procedures for this engine
Step-by-step procedures from the workshop database.
Got a Z7U-702 problem? Ask for free.
Describe the symptoms — TorqFix replies with a diagnosis cited from verified workshop data.
Get free diagnosis →Who makes these pages, and how
TorqFix was built by a mechanic — after a 2,700 km drive with five roadside repairs that no diagnostic tool could explain.
The figures on this page come from manufacturer workshop documentation and are shown as they are. The page is assembled automatically from that data — it is not written by an AI. The AI works in the chat, where it answers for your specific car. It writes nothing here.
Variants of the same model differ. Cross-check torque against the factory manual for your engine before final tightening.
Seen a figure that does not match your manual? Write to us — we correct it and note when. support@torqfix.com
The story behind TorqFix →Workshop data on this page last updated 22 Aug 2026.