D4F-702 engine — Renault 1.1 (1.1L)
1.1L · 75 hp
Engine overview
Vehicles with this engine
Factory specifications
Values from the manufacturer documentation for this engine.
Engine (general)
| Engine code | D4F-702 |
| Capacity | 1149 cc |
| Idle speed | 700 - 800 rpm |
| Idle speed | 750 - 1050 rpm |
| Inlet | 0.05 - 0.12 mm |
| Exhaust | 0.15 - 0.22 mm |
| Minimum | 12.0 bar |
| Oil pressure | 0.8 / 800 3.5 / 4000 bar/rpm |
Engine (petrol)
| Fuel system (make and type) | Magneti Marelli 5NR |
| Number of cylinders | 4 |
| Firing order | 1 - 3 - 4 - 2 |
| Ignition coil resistance, primary | 0.4 ohms |
| Ignition coil resistance, secondary | 11000 ohms |
| Spark plugs (make and type) | Champion REA 8 MCL |
| Spark plug gap | 0.9 mm |
| Injector resistance | 14.5 +/- 0.7 ohms |
| Injection pressure/system pressure | 3.5 ± 0.2 bar |
| CO exhaust gas | < 0.5 % |
| CO2 | > 14.5 % |
| HC | 100 ppm |
| O2 | 0.1 - 0.5 % |
| Lambda | 0.97 - 1.03 |
| Lambda change (Delta Lambda) | 0.03 |
| Fast-idle speed | 2600-2900 rpm |
| CO at fast-idle speed | < 0.3 % |
Cooling system
| Cap pressure | 1.2 bar |
| Thermostat opens at | 89 °C |
| Fan on at | 99 °C |
Electrical
| Battery | 40 Ah |
| Alternator | 75 A |
Capacities
| Engine sump, incl. filter | 4.8 l |
| Manual transmission | JH1 |
| Gearbox refill | 3.4 l |
| Hydraulic gear change system | 0.6 l |
| Cooling system | 5.0 l |
| Air-conditioner refrigerant | 700 ± 35 g |
| Air-conditioner compressor oil | 135 ± 10 ml |
Torque settings
| Cylinder head bolts — Stage 1 | 20 ± 2 Nm |
| Cylinder head bolts — Stage 4 | 20 Nm |
| Cylinder head bolts — Stage 5 | 230 ± 6 ° |
| Repeat stage (X) until all bolts are tightened | (3, 4, 5) |
| Spark plugs | 20 - 25 Nm |
| Exhaust manifold | 25 Nm |
| Oxygen sensor | 45 Nm |
| Oil filter | 20 Nm |
| Front hub | 280 Nm |
| Rear hub | 170 Nm |
| Wheel nuts | 105 Nm |
| Wheel bolts | 90 Nm |
Emissions
| Emission code | 70/220*1999/102 |
| Emission standard | Euro 3 (08/2000 ->) |
| CO2 average | 140 g/km |
| CO | 0.482 g/km |
| HC | 0.085 g/km |
| NOx | 0.034 g/km |
| Emission code | 70/220*1999/102A |
| Emission standard | Euro 3 (09/2000 ->) |
| CO | 0.317 - 0.482 g/km |
| HC | 0.085 - 0.094 g/km |
| Emission code | 70/220*2001/1A |
| Emission standard | Euro 3 (05/2001 ->) |
| CO2 average | 138 - 140 g/km |
| Emission code | 70/220*2001/100A |
| Emission standard | Euro 3 (06/2002 ->) |
| CO2 average | 138 g/km |
| Emission code | 70/220*2002/80A |
| Emission standard | Euro 3 (04/2004 ->) |
| CO | 0.323 g/km |
| HC | 0.055 g/km |
| NOx | 0.092 g/km |
| Emission code | 70/220*2001/100B |
| Emission standard | Euro 4 (03/2003 ->) |
Workshop procedures for this engine
Step-by-step procedures from the workshop database.
Got a D4F-702 problem? Ask for free.
Describe the symptoms — TorqFix replies with a diagnosis cited from verified workshop data.
Get free diagnosis →Who makes these pages, and how
TorqFix was built by a mechanic — after a 2,700 km drive with five roadside repairs that no diagnostic tool could explain.
The figures on this page come from manufacturer workshop documentation and are shown as they are. The page is assembled automatically from that data — it is not written by an AI. The AI works in the chat, where it answers for your specific car. It writes nothing here.
Variants of the same model differ. Cross-check torque against the factory manual for your engine before final tightening.
Seen a figure that does not match your manual? Write to us — we correct it and note when. support@torqfix.com
The story behind TorqFix →Workshop data on this page last updated 22 Aug 2026.