Checking fuel pressure when the engine is running and vehicle is in gear (engine codes CCZA, CCZB, CCZC, CCZD) — VW

🧭 Before you start

Fits: VW Tiguan I (5N, 2007–2016)

• Special tools named: VAS 6550/1, VAS 5052

Don't miss

• For vehicles with auxiliary heater the metering pump V54 connector must be separated additionally.
• First ensure that 5-pin wiring connection (1) is secure by pulling the connector without pressing the catch. The connector can cause a fault if it has not been fitted correctly.
• Make sure that drain tap is closed and cut-off taps are open.

🔧 Engine codes this applies to

📐 67 workshop diagrams for CCZA

Real factory drawings for this job — timing marks, bolt locations and routing. Locked in the free view.

📋 Procedure

1. Remove bench seat General body repairs, interior72Removing and installing bench seat.
2. Remove right (in direction of travel) cover from fuel delivery unit. [Note: For vehicles with auxiliary heater the metering pump V54 connector must be separated additionally.]
3. First ensure that 5-pin wiring connection (1) is secure by pulling the connector without pressing the catch. The connector can cause a fault if it has not been fitted correctly.
4. ⚠ The fuel line is under pressure.Risk of injury to eyes and skin from fuel.Wear eye protection and protective clothing to avoid eye injuries and skin contact. Before loosening hose connections, wrap a cloth around the connection. Then release pressure by carefully opening the connection point. — Pull off supply line (2) and catch escaping fuel with a cloth.
5. Connect pressure testerVAS 6550 to fuel supply line with adapterVAS 6550/2 and VAS 6550/1.

6. Fit connector cableVAS 5051/66 to pressure testerVAS 6550 and to vehicle diagnosis and service information systemVAS 5052 B.
7. Make sure that drain tap is closed and cut-off taps are open.
8. Switch on pressure testerVAS 6550.
9. Connect vehicle diagnosis and service information systemVAS 5052 B to vehicle.
10. Select Guided fault finding in VAS 5052 B.
11. Carry out vehicle identification.
12. Using the GoTo button, select the following menu options one after the other:
13. Follow instructions on vehicle diagnosis and service information systemVAS 5052 B.

Other VW procedures

• Removing and installing air filter housing – VW Golf Cabriolet · 2 torque figures
• Removing and installing intake manifold with fuel rail
• Assembly overview - cylinder block, gearbox end · 3 torque figures
• 4-cylinder direct injection engine (1.8 ltr., 2.0 ltr. 4-valve TFSI) — Installing engine
• Removing and installing coolant pipes (front) – Audi A8 D3
• Removing engine · 41 torque figures
• Removing and installing camshaft – VW Golf Cabriolet · 47 torque figures
• Adjusting valve timing – VW Passat B5 · 83 torque figures
• Removing and installing camshafts – VW Passat B6 · 39 torque figures
• Removing and installing coolant pump · 53 torque figures