TorqFix

Gearbox removal & installation: Peugeot 3008, 5008 MCM (EP6CDT, EP6DT)

Step-by-step gearbox removal & installation for the Peugeot 3008, 5008 MCM (EP6CDT/EP6DT): 16 steps. What to remove, in what order, and what to check.

Workshop procedure for PEUGEOT — the exact step sequence and torque figures, straight from real workshop data.

16 steps 2 engine codes

🧭 Before you start

Fits: platform codes 1.6, THP

Don't miss

  • Remove the starter motor but do not disconnect

🔧 Engine codes this applies to

EP6CDT(5FV)EP6DT(5FX)

📋 Procedure

  1. Concentric slave cylinder:
  2. Remove the turbocharger coolant pump
  3. Gearbox to engine:
  4. Remove the starter motor but do not disconnect
  5. Note: Move it aside
EP6CDT(5FV)? Steps differ between engine variants — check this job against your exact car before you commit to it. Check my car — free →
  1. Secure to the vehicle
  2. Remove the bolts from the engine wiring bracket
  3. Move the harness aside
  4. Use a hoist to support the gearbox
  5. Remove the engine/gearbox attaching bolts
  6. Separate the gearbox from the engine
  7. Remove the gearbox

Other PEUGEOT procedures

Who makes these pages, and how

TorqFix was built by a mechanic — after a 2,700 km drive with five roadside repairs that no diagnostic tool could explain.

The figures on this page come from manufacturer workshop documentation and are shown as they are. The page is assembled automatically from that data — it is not written by an AI. The AI works in the chat, where it answers for your specific car. It writes nothing here.

Variants of the same model differ. Cross-check torque against the factory manual for your engine before final tightening.

Seen a figure that does not match your manual? Write to us — we correct it and note when. support@torqfix.com

The story behind TorqFix →

Workshop data on this page last updated 20 Sep 2026.