Corsa B Clutch (Without service aperture) — OPEL / VAUXHALL

🧭 Before you start

Fits: platform codes 1.5, D, |, TD, 1.6I, 16V, 1.7

• Renewed: oil seals

Don't miss

• We recommend that the clutch release bearing should always be renewed
• Do not bring any grease into contact with the clutch plate facing, clutch cover surface or flywheel surface
• Always renew the drive shaft seals

🔧 Engine codes this applies to

📋 Procedure

1. Fit the clutch plate and the clutch cover
2. Reset volatile memories after reconnecting the battery cables
3. We recommend that the clutch release bearing should always be renewed
4. Clutch alignment tool:
5. Tighten the clutch cover bolts

6. Check the clutch housing for leaks; check the crankshaft end seal thoroughly
7. Check the flywheel friction surface for condition and wear
8. Grease the thrust bearing inner bore, drive plate splines and release fork pivot points
9. Note: Do not bring any grease into contact with the clutch plate facing, clutch cover surface or flywheel surface
10. Renew the oil seals if necessary
11. Always renew the drive shaft seals
12. Remove the clutch release fork with the clutch release bearing

Other OPEL / VAUXHALL procedures

• Opel Corsa C 1.2 CDTI timing chain replacement
• Opel Astra G 2.2 DTI Y22DTR timing chain replacement
• Opel VectraC, Signum 2.8 Z28NEL timing chain replacement
• Opel Astra G 2003 2.0 DTI Y20DTH timing chain replacement
• Opel Astra G X Y 20DTL 2.0 DTI X20DTL timing chain replacement
• Opel Corsa D timing chain replacement
• Opel Corsa D 1.2 CDTI Z13DTH/Z13DTJ timing chain replacement
• Opel Meriva 1.2 CDTI timing chain replacement
• Opel Meriva 1.4 Z14XEP timing chain replacement
• Opel Speedster 2.2 Z22SE timing chain replacement