Gearbox removal & installation: Nissan Note 1.4i JH3 (CR14DE)
Step-by-step gearbox removal & installation for the Nissan Note 1.4i JH3 (CR14DE): 82 steps. What to remove, in what order, and what to check after.
Workshop procedure for NISSAN — the exact step sequence and torque figures, straight from real workshop data.
🧭 Before you start
Fits: platform codes 1.4, 16V
- Opens: clutch fluid
🔧 Engine codes this applies to
📋 Procedure
Preparation and removal
- Disconnect the battery
- Remove the battery
- Remove the clips
- Remove the clips
- Remove the air filter housing
- Remove the air filter
- Slide the tube in the direction shown
- Disconnect the cables from the gearbox bracket
- Starter motor:
- Disconnect the starter motor electrical connections
- Remove the clear plastic tube
- Raise the vehicle
- Remove the front wheels
- Remove both front wheel arch liners
- Remove the lower engine cover
- Disconnect the earth cable
- Disconnect the exhaust pipe mount
- Disconnect the oxygen sensor connection
- Front exhaust pipe:
- Remove the front exhaust pipe
- Remove the lock plate
- on the left- and right-hand sides
- Remove the wheel speed sensor
- on the left- and right-hand sides
- Remove the drive shaft nuts
- Disconnect the steering arm ball joints from the wheel bearing housings
- Disconnect the suspension strut from the wheel bearing housing
- Disconnect the drive shafts from the wheel bearing housings
- Disconnect the drive shafts from the gearbox
- Disconnect the earth cable from the gearbox
- Check that all the wiring and hoses are disconnected
- Fit a transmission jack to support the transmission
- Remove the rear gearbox support
- Note: Do not remove
- Remove the gearbox support bolt(s)
- Remove the gearbox support
- Remove the engine/gearbox attaching bolts
- Remove the gearbox
Installation and checks
- Bleed the hydraulic clutch system
- Top up the clutch fluid if necessary
- Refit the air inlet hose
- Return the tube to its original position
- Repeat the procedure if required
- Until no air is present in the fluid
- Return the pin(s) to original position
- Top up the clutch fluid if necessary
Other NISSAN procedures
- Nissan Micra K12 CR timing chain replacement
- Nissan Note 1.4 CR14DE timing chain replacement
- Nissan non type specific 2.0 dCi timing chain replacement
- Nissan X-Trail T30 QR20, 25 QR20DE timing chain replacement
- Nissan X-Trail T31 2.4 QR25DE timing chain replacement
- Nissan Kubistar 1.5 dCi auxiliary belt replacement
- Qashqai - K9K - RS6F94R/RS6F52A
- Nissan Qashqai RS6F94R 2.0 gearbox removal & installation
- Nissan Primera P12 2.2 dCi YD22DDTI timing chain replacement
- Nissan 2.0 D CD20 timing belt replacement
Who makes these pages, and how
TorqFix was built by a mechanic — after a 2,700 km drive with five roadside repairs that no diagnostic tool could explain.
The figures on this page come from manufacturer workshop documentation and are shown as they are. The page is assembled automatically from that data — it is not written by an AI. The AI works in the chat, where it answers for your specific car. It writes nothing here.
Variants of the same model differ. Cross-check torque against the factory manual for your engine before final tightening.
Seen a figure that does not match your manual? Write to us — we correct it and note when. support@torqfix.com
The story behind TorqFix →Workshop data on this page last updated 20 Sep 2026.