Ancillary belt M9R (Qashqai) — NISSAN

🧭 Before you start

Fits: platform codes 2.0, DCI

• Timing position: the crankshaft or camshaft is set and locked during this job
• Special tools named: locking pin
• Renewed: tensioner

Don't miss

• The ancillary drive belt can only be fitted once. When removal is required, always fit a new belt

🔧 Engine codes this applies to

📋 Procedure

Preparation and removal

1. Note: The ancillary drive belt can only be fitted once. When removal is required, always fit a new belt
2. Disconnect the battery earth cable
3. Disconnect the positive battery cable
4. Raise the vehicle
5. Remove the engine lower cover

6. Remove the front right wheel
7. Remove the right-hand inner wing splash guard
8. Remove the reinforcement plate on the lower cross member

Installation and checks

9. Turn the tensioner pulley clockwise until the locking pin fits
10. Use a wrench
11. Refit all other parts in the reverse order of removal
12. Renew the idler pulley
13. Renew the tensioner

Other NISSAN procedures

• Renault non type specific 2.0 dCi timing chain replacement
• Nissan Micra K12 CR timing chain replacement
• Nissan non type specific 2.0 dCi timing chain replacement
• Nissan X-Trail T30 QR20, 25 QR20DE timing chain replacement
• Nissan X-Trail T31 2.4 QR25DE timing chain replacement
• Nissan Kubistar 1.5 dCi auxiliary belt replacement
• Nissan Qashqai 1.5 dCi K9K timing belt replacement
• Nissan NV200 1.5 dCi K9K timing belt replacement
• Nissan Cube, Tiida 1.5 dCi K9K/K9K-728 timing belt replacement
• Nissan Primera 1.9 dCi F9Q timing belt replacement