Freelander clutch 00-06 petrol — LAND ROVER
Freelander clutch 00-06 petrol on Land Rover: 25 steps, engines 18K4F. What to remove, in what order, and what to check after.
Workshop procedure for LAND ROVER — the exact step sequence and torque figures, straight from real workshop data.
🧭 Before you start
Fits: platform codes 1.8, 16V
- Timing position: the crankshaft or camshaft is set and locked during this job
- Special tools named: locking tool
- Renewed: oil seals, drive shaft seals
Don't miss
- Always renew the concentric slave cylinder
- Always renew the drive shaft seals
🔧 Engine codes this applies to
📐 15 workshop diagrams for 18K4F
Real factory drawings for this job — timing marks, bolt locations and routing. Locked in the free view.
📋 Procedure
- Fit the clutch alignment tool
- Fit the crankshaft locking tool
- Crankshaft locking tool:
- Clutch alignment tool:
- Note: Always renew the concentric slave cylinder
- Check the clutch housing for leaks; check the crankshaft end seal thoroughly
- Note: Fit the clutch plate with the lettering facing the gearbox
- Check the flywheel friction surface for condition and wear
- Tighten the bolts in several stages, in a criss-cross pattern
- Refit the gearbox
- Renew the oil seals if necessary
- Always renew the drive shaft seals
Ask TorqFix about your Land Rover 18K4F — it answers with the exact sequence for that engine and the workshop drawing for each step. First question is free after a 20-second sign-up, no card.
Ask about your Land Rover 18K4F — free → or sign up free to see the drawingsOther LAND ROVER procedures
- TF 160 VVC timing belt
- TF 115/135/120 timing belt
- Freelander 97-00 gearbox petrol
- Freelander clutch 97-00 petrol
- Land Rover KV6 2.5 25K4F timing belt replacement
- RR Sport 3.0Td Injection pump belt
- Defender 2.2 Td4 MT82 gearbox
- Defender 2.4TD MT82/M66 gearbox
- Discovery 3/4 (ZFS6-53/M66) gearbox
- Defender (L316) R380 gearbox
Who makes these pages, and how
TorqFix was built by a mechanic — after a 2,700 km drive with five roadside repairs that no diagnostic tool could explain.
The figures on this page come from manufacturer workshop documentation and are shown as they are. The page is assembled automatically from that data — it is not written by an AI. The AI works in the chat, where it answers for your specific car. It writes nothing here.
Variants of the same model differ. Cross-check torque against the factory manual for your engine before final tightening.
Seen a figure that does not match your manual? Write to us — we correct it and note when. support@torqfix.com
The story behind TorqFix →Workshop data on this page last updated 20 Sep 2026.