Wrangler 2.4 ED1 ancillary drive belt removal — JEEP
Wrangler 2.4 ED1 ancillary drive belt removal on Jeep: 12 steps, engines ED1. What to remove, in what order, and what to check after.
Workshop procedure for JEEP — the exact step sequence and torque figures, straight from real workshop data.
🧭 Before you start
Fits: platform code 2.4
🔧 Engine codes this applies to
📋 Procedure
- Turn the tensioner bolt until the tensioner contacts the belt
- Turn the tensioner clockwise to release the belt tension
- Remove the ancillary drive belt
- Vehicles with air conditioning:
- Vehicles without air conditioning:
- Reconnect the battery earth cable
Other JEEP procedures
Who makes these pages, and how
TorqFix was built by a mechanic — after a 2,700 km drive with five roadside repairs that no diagnostic tool could explain.
The figures on this page come from manufacturer workshop documentation and are shown as they are. The page is assembled automatically from that data — it is not written by an AI. The AI works in the chat, where it answers for your specific car. It writes nothing here.
Variants of the same model differ. Cross-check torque against the factory manual for your engine before final tightening.
Seen a figure that does not match your manual? Write to us — we correct it and note when. support@torqfix.com
The story behind TorqFix →Workshop data on this page last updated 20 Sep 2026.