Integra D15A1 1985 - 1989 — HONDA
Integra D15A1 1985 - 1989 on Honda: 28 steps, engines D15A1. What to remove, in what order, and what to check after.
Workshop procedure for HONDA — the exact step sequence and torque figures, straight from real workshop data.
🧭 Before you start
Fits: platform code 1.5
- Timing position: the crankshaft or camshaft is set and locked during this job
Don't miss
- Always fit a new timing belt after removal
🔧 Engine codes this applies to
📋 Procedure
- Tensioner:
- Fit the timing belt
- Always fit a new timing belt after removal
- Remove both timing belt covers
- Tighten the tensioner
- Loosen the tensioner
- Check the timing marks again
- Refit all other parts in the reverse order of removal
- Note: Avoid bending, torsion or traction
Other HONDA procedures
- Honda Accord 2.0 K20A6/K20Z2 timing chain replacement
- Honda Accord 2.4 K24A3 timing chain replacement
- Honda Stream 2.0 K20A1 timing chain replacement
- Honda FRV 2.0 K20A9 timing chain replacement
- Honda CRV engines 2002> timing chain replacement
- Honda Civic FN, FK L13A, L13Z 1.3 timing chain replacement
- Honda Civic EM, EP, ES, EU, EV 2.0 timing chain replacement
- Honda Accord, Civic 2.0 TD 20T2N/20T2R timing belt replacement
- HR-V Belt tension
- Brake fault
Who makes these pages, and how
TorqFix was built by a mechanic — after a 2,700 km drive with five roadside repairs that no diagnostic tool could explain.
The figures on this page come from manufacturer workshop documentation and are shown as they are. The page is assembled automatically from that data — it is not written by an AI. The AI works in the chat, where it answers for your specific car. It writes nothing here.
Variants of the same model differ. Cross-check torque against the factory manual for your engine before final tightening.
Seen a figure that does not match your manual? Write to us — we correct it and note when. support@torqfix.com
The story behind TorqFix →Workshop data on this page last updated 20 Sep 2026.